The engine mount of the large Piaggio / Gilera two-stroke models to the noticeable engine vibration was suspended in a Schwingenparallelogramm to minimize . The mounting of the swing arm frame was designed for cost reasons it with plastic sleeves . These tend over time to deflect causing the engine in the wrong context dependent and a clear play on the engine transversely to the direction of travel can be determined . Often a reason for MOT to refuse plaque. just such a subject to wear rubber silent blocks directly in the motor housing . Here, too , wear the same symptoms is noticeable . A replace these components can drive the scooter back on track making sure TIP : . Swing The bolts are made of untreated steel . Are the O-rings that should seal the plastic bushings from splash defective / porous rust the axles. Often the surface of the axes is so scarred that the new bushings can not accomplish much by the corrosion . Therefore, this may also replace and coat before mounting everything with waterproof grease p > < choose p > the tightening torque link attachment in not too high. Otherwise clamp the rocker and the roller vibrates strongly . The great Silent block in the middle of the rocker only dampens the up and down movement of the rocker and has virtually no influence on the management side of the swingarm . From the design and installation is very complicated without the appropriate tools . If the block is not yet clearly torn / porous , it can remain in the vehicle. Warning: this block are in the early Piaggio models even in a small execution ( SKR , TPH ) . This is no longer available and not later , listed here , replaceable Tightening torque for the studs . < / P > swing arm / motor 33- 41NM arm / frame 33 - 41NM Shocks / motor 33- 41NM < / li > ul> delivery: < / p > 4x plastic bushing swing 4x O. ring 21x3.00mm swing 2x Silent block engine 1x Silent block Motorschwingarm < / li > ul>
To evaluate products you need to be logged in.