clutch holder/ clutch holding tool -101 OCTANE- 39mm

Tool for removing the clutch bell (holding tool) and loosening the large nut under the clutch bell. This tool is needed to perform work on the clutch, rear converter and back pressure spring.

Wrench size: 39mm
Diameter per pin: 11.2mm
Distance between pins: 60mm

Used on Honda, Peugeot, Kymco, SYM and most Minarelli and China engines 50cc and 125/150cc.

If you are not sure, the necessary wrench size must be measured on the nut of the clutch before ordering._{AI-translation}