all-in-one timing tuning kit for the DEPS 4
So it is possible to turn something on the timing screw
without sacrificing compression, having
to drive an unnecessarily high
pinch point,
or having to turn off / mill down the head.
By the use of high-quality material & Alloy, which concerns the seal & Pressure characteristics,
it is without further ado possible, e.g. a 0.2mm head gasket to drive
without leakage problems to get.
The alloys have a better heat dissipation
than the original gaskets with a better pressure resistance.
Original the following timing is given :
Outlet 182°
Overflow 122,5°
Qk : 0,75/0,80
*To use/clear e.g. the channels/ports completely at BDC,
a foot gasket of 0,4mm would be necessary, but you end up with a QK of
about 1,15 (depending on cylinder & cylinder head tolerance).
With the MCGASKET DEPS4 kit it is possible to optimize the timing as you need it
and that with a low pinch point.
Included in the kit :
1x foot gasket deps4/deps2020 0,40mm Alu 1x
foot gasket deps4/deps2020 0,50mm Alu
1x head gasket deps4/deps2020 0,20mm Copper
1x head gasket deps4/deps2020 0,30mm Copper
It should be noted that the gaskets are very accurately manufactured & the original,
or rather, with the original 1 to 1 from the
The dimensions of the gaskets are 1 to 1 the same
as the original gaskets, so it may be necessary
to rework the holes for the stud bolts.
AI-translation