This is the German made tool for dismantling/assembling the drive side ball bearing (6305) in the Lambretta engine. This tool not only makes replacement quick but also precise. To remove the bearing, heat it in the engine and then simply pull it out with the tool. To install the ideally cold bearing, pull it into a well warmed engine housing.
For safe and quick work, have a 24 mm open-end wrench and a 14 mm hexagon socket ready.
Three attachment plates if necessary. with centering heel
Massive from the fully turned construction
Thanks to the blue chromating it is permanently protected and even after years of use it still makes the professional impression on the tool wall that it deserves. Inalienable for every passionate Lambretta screwdriver. AI-translation/sub>
Rate this article now and let us know what you think.
DE | €
