License plate holder - license plate holder -TD-Customs- Vespa/Lambretta (180x200mm)
Vespa and Lambretta license plate base plate 180mm wide, 200mm high made of stainless 1.5mm stainless steel sheet.
Included is the base plate and the necessary screws for mounting.
Herewith is an end with bent and broken vibrated license plate, and it also looks clean from the
enclosed screws are also made of stainless steel.
In the license plate only four 5mm holes must be drilled at the four corners (use base plate as a drilling template).
For the purpose of clean optics, four M5 cap nuts are included, from the rear side put the screws through and
screw from the visible side with
washers and cap nuts.
The set is intended for a hole spacing on the frame of 145mm to 145mm as you
know it on very many Vespas and Lambretta
and otherwise are also quickly drilled the required holes themselves.
(TW240222)