Plug set for wiring harness -BGM PRO- type series 090 SMTO MT Sealed, Bihr, 3 plug contacts, 0.85-1.25mm², watertight-

SEALED connectors are sealed and therefore offer a very high level of protection against water, dirt and dust (class IP67). They are perfectly suited for use in areas where temperature, water, oil and gasoline resistance are important. Smaller than the conventionally used sealed plugs, the types offered here are perfect for wiring the on-board electronics of two-wheelers reliably and permanently protected.

We always offer the plugs as a pair, i.e. male and female in a set.
They are available with 2, 3, 4 and 6 plug contacts.

TIP: The contacts should be processed with crimping pliers for optimum contact and tensile strength (see accessories).

Properties:

• waterproof up to IP 67
• max. 13A
• max. 24V DC
• -40°C to +120°C

Resistant to:

• Ozone, salts, petrol, diesel, brake fluid and engine oil

Scope of delivery:

• 1x 6-pin socket housing
• 1x pin housing 6-pin
• 4x socket contact 0.55-1.25mm²
• 4x pin contact 0.55-1.25mm²
• 6x single wire seal for outer diameter 1.7-2.7mm

NOTE: The sets always contain one more plug contact than is required for the respective plug. This means you always have a reserve and can crimp a cable again if necessary.