Throttle cable guide set (throttle cable elbow) -MALOSSI- M6 x 0.75 - 160°

We stock the manifolds with different angles, so you can convert the carburetor to suit almost any installation position. As a rule, Dell'Orto carburetors are only supplied with a short adjusting screw screwed directly into the carburetor, or they have a 70°-90° angled connection piece.

For some installation positions, such as the smallframe models ala Primavera, ET3, PK etc., it makes sense to convert the existing throttle cable manifold. In this case, the throttle cable is routed to the carburetor from below, so the 180° manifold is ideal here.

However, this should only be countered carefully to avoid vibration breakage due to the large span of the elbow.

Available in the angles

• 50°
• 70°
• 90°
• 160°

Included is the manifold, the adjusting screw to be screwed into the manifold for the throttle cable play, as well as the rubber grommet for the outer cable to prevent dirt and water from penetrating.