ABS Sensor, Front Wheel PIAGGIO for Vespa GTV 300 / GTV HPE 300 Sei Giorni, Euro 4–Euro 5 (2017–2021)

Piaggio Front ABS Sensor – Vespa GTV 300 Sei Giorni

Genuine Piaggio ABS sensor for the front wheel of the Vespa GTV 300 Sei Giorni. The wheel speed sensor detects the rotation of the front wheel and provides the ABS system with the required speed signal. If the sensor is damaged or faulty, the complete sensor unit can be replaced with the corresponding genuine part.

The sensor is supplied as a pre-assembled unit with a permanently attached cable and vehicle-side electrical connector. The application-specific cable length and routing allow installation according to the original factory configuration.

Complete sensor unit for the front wheel

The product images clearly show the compact sensor head with integrated mounting eyelet. Large sections of the long black connecting cable are covered by a flexible protective spiral. Additional guide and retaining elements along the cable support the intended routing on the vehicle. The electrical connector for connection to the vehicle wiring harness is located at the end of the cable.

• Genuine Piaggio ABS sensor
• Installation position: front wheel
• Detects wheel speed for the ABS system
• Complete unit with sensor head, connecting cable and plug
• Cable with additional protective covering and guide elements
• Sensor head with integrated mounting eyelet
• Piaggio original part numbers: 1D003747 and 1D0011175

Suitable for Vespa

• Vespa GTV 300 Sei Giorni Euro 4 (2017)
• Vespa GTV HPE 300 Sei Giorni Euro 4 (2019–2021)
• Vespa GTV HPE 300 Sei Giorni Euro 5 (2020)

Installation and inspection

During installation, ensure that the sensor head is positioned correctly and that the connecting cable follows the original routing. The cable must be routed so that it is not placed under tension, kinked or at risk of damage from moving or hot components when steering or the suspension is compressed. The ABS tone ring area should also be checked for contamination and damage when replacing the sensor.

After installation, check the electrical connection and cable routing. The correct operation of the ABS system should then be verified.