High performance ignition system designed specifically for the QMI and QMJ engines.
The OEM QUALITY CDIs are on original equipment level in terms of quality. In addition, they are open CDIs. This means that there is
no rev limiter built into the CDI. This allows your engine to rev to its full potential.
The OEM QUALITY CDIs are subject to a very strict quality control. This ensures that:
- a constant and strong ignition spark is present over the entire speed rangethe
- capacitor is extremely high voltage and pulse resistantthe
- primary winding is at least at OEM level and abovethe
- transformation between
primary- to secondary coil is completely trouble-free
.
With the OEM QUALITY CDIs you always have a strong spark for optimum power output. And your engine can finally
power.
The installation is very easy: Just plug it in and your engine can rev freely.
NOTE:
Different wiring harnesses are used depending on the vehicle manufacturer.
Therefore it is possible that after installation of the new CDI the fuse of the battery blows.
If this is the case, the wiring harness should be changed on the vehicle side as follows:
The black/white cable is placed on the slot of the black cable.
The black cable remains free and should be well insulated.Only suitable for scooters with AC ignition system.
Note: Whether an AC or DC CDI is installed can be determined as follows.
- Disconnect the battery
- Switch on the ignition
- and start with the kick starter
If the scooter starts, an AC CDI is installed
.
If the scooter does not start, a DC CDI is installed.
Always check the compatibility of the original component before ordering.
AI-translation