JOLA Lasergravuren Item number: JL0546
JOLA Lasergravuren
89,00 €*
available immediately
Shipping weight 1,81 kg

With this tool, the drive shaft can be installed and removed quickly and gently-removed.

Made of quality steel 42CrMo4.

The pull-in is done by a pulling sleeve and a pulling spindle which are screwed onto the drive shaft. Two different drive shafts can be pulled in with the threads M16x1,25 and M14x1,5.

AG 1: Screw the pulling sleeve onto the drive shaft.

AG 2: Place outer sleeve on the wheel bolt and screw tight.

AG 3: Insert spindle into outer sleeve and screw into draw sleeve.

AG 4: The drive shaft is then pulled in with the M16 nut.

The drive shaft is removed with the enclosed M20 screw. This is screwed into the tightened outer sleeve until the drive shaft is pressed out.



AI-translation

Rate this article now and let us know what you think.
Matching
Customers also bought