Engine gasket set -LAMBRETTA- TV 175 (series 2-3)

Small end needle bearing -ITALKIT (16x20x20mm)- Vespa PX200, Rally180, Rally200, Cosa200, Vespa T5 125cc, Lambretta LI, LIS, SX, TV, DL, GP, Piaggio SKR, Typhoon 125, Gilera Runner125 FX, Runner180 FXR, Hexagon LX, LXT 2-stroke - silver cage

Stud -M6 x 33mm- 12-10-11mm (used for chaincase cover Lambretta LI, LIS, SX, TV, DL, GP, J50, J100, J125, Lui) - stainless steel

Stud -M8 x 47mm- 18-14-15mm (used for exhaust support / chaincase cover Lambretta LI (series 2-3), LIS, SX, TV (series 2-3), DL, GP - stainless steel

Needle circlip -DELLORTO- UB, MA

Woodruff key -PIAGGIO DIN6888- 4 x 6.5 (used for crankshaft/clutch side Vespa PX, Rally180 (VSD1T), Rally200 (VSE1T), Sprint, crankshaft/flywheel side Lambretta LI, LIS, SX, TV, DL, GP, Piaggio 250-300cc 4-stroke)

Float needle -DELLORTO- MA21, MA23 - Lambretta TV 175 (Series 1, Series 2)

Stud -OEM QUALITÄT- M6 x 25mm- 11-3-11mm (used for mag housing Lambretta LI, LIS, SX, TV (series 2-3), DL, GP, J50, J100, J125, Lui)

Kickstart rubber buffer -LAMBRETTA- Lambretta LI, LIS, SX, TV (series 2-3), DL, GP

Roller bearing -NU2205 ECP- (25x52x18mm) - (used for crankshaft flywheel side Lambretta GP, DL)

Oil seal 33x52x6mm (used for crankshaft flywheel side inner Lambretta LI (series 2-3), LIS, SX, TV (series 2-3), DL, GP)

Washer -LAMBRETTA- 13x18x1mm for rear brake arm, gear shaft in engine, clutch lever on engine

Clutch shim -SIL- Lambretta (series 1-3) - 0.8mm