Please note: The fit unfortunately does not correspond to the original Piaggio parts.
Latest version of the Power 1 LED turn signals for the Vespa GTS models from 2014.
These have very bright Blinkerled as well as, as a special feature, a bright white daytime running light strip in the plasma look at the front. At the rear, the same technology is used as a position light.
This new technology significantly increases the visual width of the rear in the dark, significantly improving perception in road traffic.
The tinted turn signals have a very noble appearance and, when not in use, are visually restrained.
The turn signals of course have an E-mark (this is visible behind the tinted glass on the plasma strip for the daytime running light / position light function raised).
Available in each case in clear glass or black tinted for front and rear or as a more economical complete set.
NOTE: If the plasma strip flashes instead of the turn signal, please disconnect the wiring at the cable lugs of the turn signal (yellow and black cable) and reverse the polarity.
PLEASE NOTE: It is possible to connect the rear position lights also as an additional brake light (additional cable material is therefore enclosed). Then however the permission expires.
Important note :
When converting from incandescent lamps to LEDs in vehicle turn signals, it can,
due to the different resistance values of the bulbs and / or the factory installed relays,
under unfavorable circumstances to malfunctions.
To avoid this from the outset, a flasher relay such as the article MN6202 or BGM6202 should be used in case of doubt.
DE | €
