Set of engine oil dipstick and transmission oil dipstick BGM PRO made of CNC milled, high-strength aluminium.
ENGINE OIL CHECK
Do not warm up engine, allow ~10min. to cool if necessary.
Place the vehicle on a level surface.
Unscrew the dipstick and clean it with a clean cloth.
Screw the dipstick back in completely.
After unscrewing the dipstick again, check whether the oil level is in the range between the two screwed-in notches. The upper notch represents the limit for the maximum filling. This corresponds to the engine oil filling quantity of 1300ml and must not be exceeded. If the engine is warm, the oil level is lower. If necessary, let the engine cool down for 10 minutes and check again.
The lower notch represents the minimum oil level. The difference between the two marks is approx. 200ml. If the oil level is below the notch, add oil to the engine accordingly.
After a successful check, screw the dipstick back in and tighten it sufficiently.
ENGINEOIL CHECK
Place the vehicle on a flat surface.
Unscrew the dipstick and clean it with a clean cloth.
Screw the dipstick back in completely.
After unscrewing the dipstick, check that the oil level reaches the notch.
If the oil level is below the notch, add oil to the engine accordingly.
After a successful check, screw the dipstick back in and tighten it sufficiently.
ATTENTION !
Not suitable for HPE models