back
CIF Item number: CIF5637TGF
CIF

Speedometer cable complete -CIF adapter (2.0mm => 2.7mm)- Vespa GT125 (VNL2T), GTR125 (VNL2T), TS125 (VNL3T), Sprint150 (VLB1T), Sprint Veloce, Rally180 (VSD1T), Rally200 (VSE1T)

Compatible: Rally, Sprint, GT, GTR and TS with 10 inches
Square top (speedometer): approx. 2.0 mm
Square bottom (drive in the fork): 2.7 mm
Typical reason: Speedometer and drive come from different versions
Benefit: clean frictional connection without slipping through a too small core
Important: Measure dimensions before ordering
14,90 €*
available immediately
Shipping weight 0,216 kg
Information on product safety
Report error

Speedometer cable complete for Rally, Sprint, GT, GTR and TS (10 inch)

This conversion speedometer cable is intended for speedometers that have a small square connection (approx. 2.0 mm) on the instrument, while a speedometer drive with a large mount (2.7 mm) is usually installed in the fork ex works. This allows mixed components from restoration or conversion to be combined cleanly.

10 inch fork Top 2.0 mm Bottom 2.7 mm For mixed setups Prevents slippage

Note on original equipment

From the factory, many vehicles have the same square at the top of the speedometer and at the bottom of the speedometer drive. In practice, however, the speedometer and drive are often mixed during restorations and conversions. With this special version, a speedometer with a small connection (approx. 2.0 mm) can be combined with a 2.7 mm speedometer drive.

Technical information

Requires a speedometer drive (pinion or worm) with a 2.7 mm square mount in the fork (standard on the models mentioned).
Prevents slippage if too small a core runs in a 2.7 mm drive.
Check before ordering: Measure the square dimension at the bottom of the drive and at the top of the speedometer (approx. 2.7 mm and 2.0 mm).

Check before ordering: how to measure correctly

On the speedometer: Measure the square at the instrument connection (should be approx. 2.0 mm).
On the drive in the fork: Measure the square socket (should be 2.7 mm).
If both sides are approx. 2.0 mm, you do not need this version (see tip below).

Typical applications

Rebuild or replacement speedo with small square (approx. 2.0 mm), but existing 2.7 mm speedo drive in the 10-inch fork.
Conversion or restoration vehicle in which the speedometer and speedometer drive come from different assemblies or versions.
You deliberately want to use a speedometer with a small square without converting the speedometer drive in the fork to a small size.

Tip: when do you not need this adapter version?

If your speedometer drive also has the small square (approx. 2.0 mm) at the bottom.
Then a speedometer cable with a small square fits at the top and bottom (without the adapter version).

FAQ

Measure the square at the connection of the speedometer instrument. For this version, the dimension is typically approx. 2.0 mm.
Check the square mount on the speedometer drive in the fork. If the mount is designed for 2.7 mm, this speedometer cable fits the large drive at the bottom.
In practice, slippage can occur: The core is not driven cleanly, the display becomes choppy or fails. This design prevents precisely this problem.
No, then you do not need an adapter version. In this case, a speedometer cable with a small square at the top and bottom is the right choice.
No, as long as the speedometer has the small square (approx. 2.0 mm) at the top and the drive is designed for 2.7 mm at the bottom. It is only important to check both dimensions in advance.
Matching
Accessories
Matching
Customers also bought