Turn signal -MOTOGADGET handlebar turn signal- m.blaze disc - polished aluminum - clear glass - right

Motogadget m.blaze disc - LED handlebar blinker right, polished

Moto Gadget LED handlebar end blinker - with E-mark

The Moto Gadget handlebar end blinker is extremely flat and appears neutral and inconspicuous thanks to the transparent lens. This makes it suitable for many styles and a wide variety of motorcycles. The technology is highly innovative and impresses with its very good function and formal beauty. The very bright LED emits the light into a precisely calculated plastic body. This emits a very bright light, particularly in the direction of travel to the front. This makes the blinker directional (different indicators for left and right). In the EU, the blinker has homologation for use as a front blinker.

Vehicles that also have indicators at the rear ex works must retain these. The indicators are intended for use with 12V direct current (DC / battery). Direct connection to an alternating current (AC) on-board power supply (many old Vespas) is not possible.

• Selected high-performance LEDs with maximum efficiency and a total output of 7W with a service life of more than 50,000 hours
• IC-controlled constant current regulation clocked at 330kHz
• A special collimator optic that precisely couples the light from the LED into the plastic body

The discreet aluminum housing is only used for the stable attachment of the glass body and the integration of control electronics and high-end LEDs. The blinker can be operated like any standard LED blinker with load resistors or all load-independent flasher relays.

Advantages

• Barely noticeable on the handlebars when switched off
• Extremely bright light to the front, clearly visible light to the rear
• State-of-the-art high-performance LED technology IntensiLED
• Electronic voltage conditioning and safe protection electronics
• Indicator light can be omitted
• Closes the handlebar end harmoniously

Scope of delivery

• Single handlebar end blinker m.blaze disc left or right with clamp for steel and aluminum handlebars (22 mm and 1 inch handlebars) with an inner diameter of 14 mm to 21 mm
• Connection cable with approx. 100 cm.
• Installation instructions

Installation data

• Diameter: 35 mm
• Total length over all: approx. 68 mm
• Partial length outside the handlebar: 20 mm
• Partial length inside the handlebar: 48 mm
• Cable length: approx. 100 cm
• Weight: approx. 40 g
• 12 Volt DC
• With E-mark (no TÜV approval necessary)