EGIG PERFORMANCE sports clutch - One Finger Clutch 2.0 - smooth-running clutch for smallframe engines up to approx. 47 hp

  • 5 cork/carbon disks
  • 4 steel intermediate plates
  • Bearing-mounted pressure plate
  • also fits into an original primary without repkit
  • only for repkits bolted from the rear (with repkits bolted from the outside, the bolt heads can touch the inner basket)
  • 500ml SAE 30
  • No spacers necessary
  • The pads of the Xl2/HP 4 disks can also be used or Fabbri 4s carbon disks
  • 6 springs 30Ps 26nm
  • 8 springs 39hp 32mm
  • 8+4 springs 45hp 36nm (extra)
  • 8+8 springs 50hp 40nm (extra) The additional inner springs, marked as extra, must be purchased separately.
The number of springs can be reduced by the 5 washers, resulting in an extremely easy to pull clutch. In conjunction with an Xl2 cover, the clutch is pulled with one finger. With 6 springs with the little finger. We recommend clutch levers with a small knob at the end, as these have considerably more disengagement travel than those with a large knob, so that the clutch disengages cleanly without much preload. Attention: The nut of the auxiliary shaft with washer must not be higher than 7 mm and the thread of the auxiliary shaft should not be higher than the nut. Furthermore, the housing seal should not be thicker than 0.2 mm when using a Piaggio auxiliary shaft. Both can impair the separation behavior of the clutch and adjustments must be made, e.g. spacing the auxiliary shaft.


Rate this article now and let us know what you think.
Matching
Customers also bought