complete BGM PRO rear brake cable with strong Ø3mm inner cable diameter (factory specification Innocenti) and pressed-on cable holder on the outer shell.
PROBLEM
ex works the original cable often has play in the abutment, which means that it is not exactly at an angle to the cable stop.
It is only pulled into position by the increased tension during braking.
This eats up a good part of the braking performance and unnecessarily increases the working travel at the brake pedal.
SOLUTION
The BGM PRO Superstrong outer casing has a fixed pressed-on abutment for the engine block side.
The cable casing is thus already properly guided in the cable stop of the engine.
The working travel is shortened, the response and the feedback of the brake are significantly improved.