Adjusting screws and clamping nipple / screw nipple set -BGM PRO- for Vespa and Lambretta

New clamp nipples, screw nipples and adjusting screws (clutch cable, brake cable, throttle cable) for Vespa & Lambretta in a practical set

We have optimized the clamp nipples and adjusting screws for Vespa and Lambretta, making them much easier and more reliable to use! Now new: also available in a cheaper set. The adjusting screw and clamping nipple sets belong in every glove compartment alongside a selection of spare cables. Suitable for many Vespa and Lambretta models, this set is an effective breakdown helper.

Clamping nipple / screw nipple set -BGM PRO- Lambretta LI, LIS, SX, TV (series 2-3), DL, GP

The set for Lambretta models contains the following individual parts:

Longer service life of the inner cables

The clamping nipples for the shift cables and the clutch cable are made of brass and fitted with pressure plates. The brass material used for the clamping nipples has a self-lubricating effect in the mounts of the shifter and clutch. Due to the lower friction of the clamping nipples in the mount, the cables are subjected to less bending and the risk of the cable breaking at this point is greatly reduced. The clamping nipples contain small pressure plates that protect the inner cable from fatal notching and thus prevent the individual wires from being severed when the clamping screw is tightened. The inner cable is less deformed and can therefore be loosened and re-tensioned more often without any problems. A cable puller is best suited for this. The 3.5 mm Allen key required is included in the set.

Klemmnippel lambretta, bgm6465 Clamping nipple Lambretta BGM6498,

Adjusting screws and clamping nipple / screw nipple set -BGM PRO- Vespa Wideframe, Largeframe and Smallframe

The set for the Vespa models contains the following individual parts:

Optimized adjusting screws

The adjusting screws from the BGM set are fitted with high nuts. This small change makes it easier to operate the adjusting screws with a normal open-end wrench, even in places that are difficult to access! On Vespa Smallframe models with two shift cables, the accessibility of the lock nut is significantly improved by the high design.

Optimum clamping nipple

The clamping nipples for the shift cables and the clutch cable are designed with brass pressure plates. The small pressure plates prevent a lethal notch effect and thus protect the inner cable from being severed when the clamping screw is tightened. The inner cable is less deformed and can therefore be loosened and retightened more often without any problems. A cable puller is best suited for this. The clamping nipple for all Vespa vehicles PK-XL2, HP and Cosa FL with the so-called 1-pull gearshift is designed slightly differently to the familiar counterpart for the 2-pull gearshifts. The differences can be found in the diameter (Ø7mm), the height (12.5mm) and the width across flats (2x SW8). Due to the slightly higher design, this clamping nipple is also ideal for use on the clutch arm.

Klemmnippel Vespa BGM

Clamping nipple Vespa BGM,
Trunnion kit vespa BGM[/caption] Pear

nipple adapter

The pear nipple adapters are suitable for all BGM and Piaggio inner cables. This system allows the cable to move freely in the adapter while loading and unloading. We have also addressed this issue in our cable sets. The Ø8x9mm bulb nipple adapters are suitable for practically all Vespa scooters EXCEPT the Vespa PK, PK-S and PK-XL. For all PK generations before the PK-XL2, the stepped bulb nipple adapters in the dimension Ø9x11mm are suitable.
Autor
Philipp Montforts