back
BGM ORIGINAL Item number: BGM6711
BGM ORIGINAL

Ignition coil retaining plate -BGM ORIGINAL- V50, V90, SS50, SS90, PV125

Key data

Component: Retaining plate for ignition coil
Hole spacing: 32.5 mm
OEM number: 156338 (Piaggio)
Application: Vespa Smallframe (V50, V90, SS50, SS90, PV125)
7,90 €*
available immediately
Shipping weight 0,02 kg
Information on product safety
Report error

Ignition coil bracket -BGM ORIGINAL- for Vespa Smallframe

If the ignition coil wobbles, it is often not the part that is missing, but the retaining plate. This BGM ORIGINAL retaining plate corresponds to the original design and returns the ignition coil neatly to its place - important for secure fastening, clean cable routing and reliable ignition.

BGM ORIGINAL OEM 156338 Hole spacing 32.5 mm for V50 and PV

Advantages at a glance

Original fit: corresponds to the OEM design, suitable for the original installation location.
Secure fastening: Ignition coil sits firmly again - less vibration, less cable stress.
Clean cable routing: helps to avoid chafing and contact problems.
Ideal for overhauls: a useful part when rebuilding or if the old plate is bent or corroded.

Fitting instructions

When replacing the ignition coil or overhauling the engine, it is worth replacing the retaining plate at the same time. Pay attention to the hole spacing of 32.5 mm and stress-free cable routing.

Fits the following models (excerpt)

Vespa 50 S (V5SA1T) from chassis 79680
Vespa 90 (V9A1T) from chassis 168661
Vespa 125 Primavera (VMA2T) from chassis 184086
Vespa 50 R (V5A1T R) from chassis 916006
Vespa 50 Special (V5B3T) from chassis 18998, Germany from chassis 72441
Vespa 100 Sport (V9B1T)

Note: Always check the existing equipment status for conversions. Ignition component details may vary depending on the year of manufacture.

FAQ

Typical reasons are corrosion, bent tabs or if the ignition coil no longer fits properly. A tight fit reduces vibrations and protects cables and plug connections.
The retaining plate is based on the OEM design (OEM 156338). Whether it fits for conversions depends on the ignition coil used and the installation location. The decisive factor is the hole spacing of 32.5 mm and the design of the coil.
Rate this article now and let us know what you think.
Rate this product now
OEM numbers (for comparison purposes only)
Piaggio:
156338
Matching
Accessories
Matching
Alternative products
Matching
Customers also bought