incl. VAT plus shipping costs
The conversion to a more modern stator plate/ignition type is a tried and tested means to be more durable and safer on the road. The non-contact CDI ignitions are virtually indestructible and reliable, and the luminous efficacy is many times higher with a modern, regulator-supported on-board electrical system, since not only is the voltage increased from 6Volt to 12Volt, but the ignition base plate can also generally produce more power.
For this purpose it is necessary to adjust the wiring harness, as in modern electrical systems the stator plates have all the light coils connected in series for maximum power yield and only one live cable is left as the output for the on-board voltage. This is then fed to the voltage regulator, which limits the on-board voltage to a constant 12-13Volt. This effectively prevents the dreaded domino effect of the old electrical system, in which all the bulbs burn out one after the other after the defect of a single one. Only after the regulator is the current conducted to the individual consumers. This technology also makes it possible to use a very powerful stator plate such as our BGM one, which guarantees a high light output and ignition power even at low speeds.
To use such an stator plate in the old chassis you therefore need a suitable wiring harness. Our conversion wiring loom is just the right thing for this and can also be used very universally. It is based on a reduced electrical system which lights the horn/buzzer, driving light/dipped beam light and the rear/brake light. Optionally the installation of a flasher relay is possible, the wiring harness is already prepared for it.
In connection with our BGM 12Volt voltage regulator a very modern on-board electrical system is the result, which in addition to a brilliant and powerful light output also has gimmicks such as a DC output for the charging function of a mobile phone or e.g. a navigation device.
When using our Conversion wiring harness no battery is needed. A possibly existing 6V-buzzer can be used further on, it copes with the occasional 12V without problems. Further technical information can be found in our wiring diagram.
Available as a set with matching light switch for:
NOTE: A brake light switch type normally open" is required.