Write a review
Evaluations will be activated after verification.

The fields marked with the asterisk * are mandatory.
Clicking on "Save" I accept the processing of my personal data in accordance with the Privacy statement of SCOOTER CENTER GmbH.

Item successfully added.

Engine casing bolt M7 x 94mm -VESPA- 80-14mm

Engine casing bolt M7 x 94mm -VESPA- 80-14mm
Engine casing bolt M7 x 94mm -VESPA- 80-14mm


The Vespa housings are fixed in the classic way, mostly by tie rods. Unlike stud bolts, tie rods are not screwed into the housing, but are guided through a bore hole that runs through both housing parts to be connected, and in the case of the Vespa motors are screwed on one side. The other side of the housing bolt (tie rod) has a head without a wrench but with an anti-twist device.
This technique minimizes the continuous effect on the thread, the torque distribution in the housing is better, but the main advantage is of course the more cost-effective production of the housing, because no threads have to be set here.

The 98mm engine housing bolt shown here is the longest bolt used in large frame engines such as Sprint, Rally, PX, Cosa and T5 engine housings. It is mounted at the height of the kick starter and runs through the hollow profile of the engine swing arm.
It is pushed through the housing from the clutch side, below the clutch cover. On older vehicles, this bolt is often heavily corroded in the middle, where it is exposed to both air and spray. Then the bolt is often difficult or impossible to remove from the housing.

  • Length: 98mm
  • Thread: M7
  • Material: Steel, burnished/galvanized
  • Scope of delivery: without nut, without washer or snap ring

Tip: To disassemble the engine halves, leave this bolt in the housing if it is stuck. The small motor half can still be removed and you avoid the risk of drilling out a bolt deformed by attempts to drive it out.
When fitting a new bolt, grease it well!


€2.99 *

incl. VAT plus shipping costs

Available immediately (delivery time 1-3 working days*)
P For this item you get fidelity point/s
OEM numbers (for comparison purposes only)
Piaggio 014565, 14565, S.14565, S.14566, S14566
Customers alternatively searched for
Motorgehäusebolzen | M7 98
The Vespa housings are fixed in the classic way, mostly by tie rods. Unlike stud bolts, tie rods...Continue reading

In exploded views

Fits the following vehicles


20 Jan 2018

Very good marchandise at a very good price.

11 Jan 2018

Gute Qualität und Passform !

21 Aug 2017

good price quality

14 Oct 2016

Zu teuer

3 Apr 2016


16 Feb 2016

Schnelle Lieferung, top Qualität und super Kommunikation! Sehr Empfehlenswert!

21 May 2015


12 Jan 2015

cosiglierei il prodotto

Recently viewed items